User Guide

Test and Diagnostic Operation
2 [CONFIDENTIAL] Satellite M60/M65 Series T&D Operation Handbook
The following sections explain how to execute the Test & Diagnostic Program and detail the tests
within the program.
2. Executing the Diagnostic Test
Toshiba MS-DOS is required to run the DIAGNOSTICS PROGRAM. To start the
DIAGNOSTIC PROGRAM, follow these steps:
1. Insert the diagnostics diskette #1 in the floppy disk drive and turn on the computer. (The
diagnostics diskette contains the MS-DOS boot files.) And then follow the instructions to
swap with the diagnostics diskette #2 for T&D program installed in RAM driver.
NOTE: To execute the CD test, make sure the CD is installed in the ODD drive.
The T&D Program can run by single test item when you press corresponsive English letter
of test item, or run two or more test items what you like if you choose them by “Arrow
cursors” and “Space Bar” – the wonderful thing is you can setup test loop by “Enter”
button. And it also asks you if you like to copy test log file to diskette as reference at the
end of test(s).
The test list is as the following:
A. CONFIG CHECK TEST
B. DMI CHECK TEST
C. RTC TEST
D. SPEAKER AUDIO TEST
E. LAN TEST
F. FAN ON/OFF TEST
G. MAIN BATTERY CHARGE TEST
H. FDD TEST
I. CD-ROM TEST
J. KEYBOARD TEST
K. MOUSE (PAD) TEST
L. LCD PIXELS MODE TEST
M. LID SWITCH TEST
N. HDD R/W TEST
O. BUTTON TEST
P. Speaker EQ Check/Rewrite
Q. Read 1394 GUID
The below display will show up at the beginning of T&D program.