User Guide

Replacement Procedures 4.22 Fluorescent Lamp

4.22.9 Replacing the 15.0 Inch XGA Sharp (HCSV) Fluorescent Lamp

Removing the 15.0-inch XGA Sharp (HCSV) fluorescent lamp

To remove the 15.0-inch XGA Sharp (HCSV) Fluorescent Lamp, follow the steps below and

refer to Figures 4-144 to 4-153.

1. Turn the LCD module face down, and remove the protection cover SC (A), protection

cover G (B), fixing tapes 1 (C) and fixing tape 2 (D).

CAUTION: 1) Be careful not to damage the TCP and chip.

2) Discard the tapes removed.

3) The protection cover G (B) is reused. Do not peel off the place sticked to

the bezel.

Protection cover SC

Protection cover G

Fixing tape 1

Fixing tape 2

Figure 4-144 Replacing Sharp fluorescent lamp (XGA-HCSV) (1)

4-144 Satellite A50/TECRA A2 Maintenance Manual (960-478)