User Guide

4.22 Fluorescent Lamp Replacement Procedures

8. Install the bezel (E) on the lamp cover and hook the one latch on the lamp cover and

one latch on the P-chassis.

Be careful not to stick the

protection cover G on the

TCP

(1) Hitch the hook of the bezel on

the rib of the P-chassis.

(2) Lean the bezel on the lamp cover

without interference with the

TCP

Lump cover side

Figure 4-140 Replacing Sharp fluorescent lamp (XGA-CSV) (20)

Make sure of mating of the bezel and the rib of the P-chassis.

Make sure of mating of the bezel and

the rib of the P-chassis.

Make sure of mating of the bezel and the rib of the P-chassis.

Figure 4-141 Replacing Sharp fluorescent lamp (XGA-CSV) (21)

Satellite A50/TECRA A2 Maintenance Manual (960-478) 4-139