User Guide

4.22 Fluorescent Lamp Replacement Procedures

4. Stick the outside tape and install the cover shield.

1) Stick the tape shield and adhesive tape to fix the top case.

NOTE: Be careful not to apply excessive force to the top case.

2) Install the cover shield (C).

NOTE: Be careful not to apply excessive force to the control PCB.

CAUTION: Wear anti-static gloves to prevent circuit damage to the source PCB.

3) Install the cover shield (G).

NOTE: Be careful not to apply excessive force to the gate TCP.

4) Stick the adhesive tape to fix the B/L wire.

NOTE: Be careful not to apply excessive force to the B/L wire.

Cover shield (C)

Cover shield (G)

Adhesive tape

Tape shield

Figure 4-82 Replacing 15.0 Inch LG.Philips fluorescent lamp (XGA) (8)

Satellite A50/TECRA A2 Maintenance Manual (960-478) 4-95