User Guide

4 Replacement Procedures 4.22 Fluorescent Lamp
4
4.22 Fluorescent Lamp
This system uses LCD modules from the following suppliers. The procedure for replacing the
fluorescent lamp is different for each LCD module. Refer to the appropriate procedure.
Type Part No. Supplier Section
14.1 inch
G33C0001Z110 CHIMEI 4.22.1
(XGA)
G33C0001P110 Samsung
4.22.2
G33C0000L110
G33C0001Q110
Samsung 4.22.3
15.0 inch
G33C0001K110 LG.Philips
4.22.4
(XGA)
G33C0000Q310 Sharp 4.22.5
G33C0001Y110 CHIMEI
4.22.6
G33C0001W110 LG.Philips
4.22.7
G33C00017110 Sharp
4.22.8
G33C0001R110 Sharp 4.22.9
G33C0000R110
15.0 inch
(SXGA+)
G33C0001X110
LG.Philips 4.22.10
NOTE: - When working with a LCD module, always use a flat, grounded table.
(1) Handle the backlight unit in the environment without dust, such as on the clean
bench. Keep the worktable free from any screws or other material that may scratch
the LCD surface.
(2) Use an anti-static or protective sheet.
(3) When replacing the FL unit, cover with a finger protector or similar to prevent
dirtying or scratching the LCD panel.
(4) Take care when handling the lamp. Excessive force may break the lamp.
(5) Take care not to dirty or deform the lamp reflector.
(6) Ensure always that the power of the LCD module is turned off before connecting or
disconnecting cables and connectors.
4-66 Satellite A50/TECRA A2 Maintenance Manual (960-478)