User Guide

4 Replacement Procedures 4.21 Wireless LAN Antenna/Speaker/Hinge
4-66 Satellite A50/TECRA A2 Maintenance Manual (960-478)
7. Install the display cover on the display assembly and secure the hinges and the
display cover with the following screws.
• M2.5x6C PSP TIGHT screw x4
• M1.5x5C SUPER THIN screw x2
8. (For wireless LAN models only)
Fit the wireless LAN antennas to the lines on the back side of the display cover with
double-sided adhesive tapes. Pass the wireless LAN antenna cables along the lines
and secure them with five acetate tapes.
9. (For wireless LAN models only)
Pass the wireless LAN antenna cables toward the back side of the display assembly.
10. Install the LCD cable and put the LCD cable hold plate on it. Secure the plate with
the following screw. When installing, hook the right projection to the edge of the
chassis. Make sure the red line on the cable comes to the end of the hinge cover.
Secure the cable with the insulator.
• M2x4Z SUPER THIN screw x1
11. Install the right and left hinge caps and secure them with the following screws.
• M2.5x6B THIN BIND screw x1
12. Pass the wireless LAN antenna toward back side of the base assembly and hook them
on the guides. Pass the cables to the center of the base assembly.