User Guide

4 Replacement Procedures 4.19 LCD Unit/FL Inverter
3. Remove the following screw fixing the FL inverter.
• M2x4Z SUPER THIN BIND screw x1
4. Peel off the insulator and disconnect two cables from the FL inverter. Remove the
FL inverter.
5. Remove the following screws fixing the LCD unit.
• M2x4Z SUPER THIN BIND screw x4
6. With the bottom edge of the LCD unit resting on the display cover, raise the top edge
of the LCD unit. Peel off the glass tape and disconnect the LCD cable from the
connector on the back of the LCD.
7. Remove the LCD unit from the display cover.
M2x4Z SUPER THIN BIND
LCD Cable
Glass Tape
FL Inverter
M2x4Z SUPER THIN BIND
Insulator
M2x4Z SUPER THIN BIND
Display Cover
Figure 4-38 Removing FL Inverter and LCD Unit
4-52 Satellite A50/TECRA A2 Maintenance Manual (960-478)