User Guide

4.14 Fan 4 Replacement Procedures
4.14 Fan
Removing the Fan
The following describes the procedure for removing the fan (See Figure 4-29).
1. Disconnect the fan cable from the connector on the system board.
2. Remove the following screws and remove the fan module by raising it up.
• M2.5x4B THIN BIND screw x2
M2.5x4B THIN BIND
PJ8770
Fan Module
Figure 4-29 Removing Fan Module
Installing the Fan
The following describes the procedure for installing the fan (See Figure 4-29).
1. Connect the fan cable to the connector PJ8770 on the system board.
2. Install the fan on the base assembly and secure it with the following screws.
• M2.5x4B THIN BIND screw x2
Satellite A50/TECRA A2 Maintenance Manual (960-478) 4-41