User Guide

4 Replacement Procedures 4.13 Connector Board
M2.5x2.8S THIN BIND
Connector Board
PJ4610
PJ3502 or PJ5640
Figure 4-28 Removing Connector Board
USB I/F Cable
Connector Board Cable
Core
DC-IN Cable
Installing the Connector Board
The following describes the procedure for installing the connector board (See Figure 4-27, 4-
28).
1. Install the connector board from the side with I/O port on the base assembly and
secure it with the following screws.
• M2x2.8S THIN BIND screw x1
2. Connect the connector board cable to the connector PJ3502 (parallel port type) or
PJ5640 (TV jack type) of the connector board.
3. Pass the DC-IN cable along the bosses near rear and USB I/F cable along the bosses
of the front side. Connector the USB I/F cable to the connector PJ4610 (Parallel
port type, TV jack type) on the connector on the connector board.
4. Install the harness holder and secure it with the following screws.
• M2.5x4B THIN BIND screw x2
5. Set the core of the DC-IN cable on the harness holder and install the DC-IN jack in
the slot of the base assembly.
4-40 Satellite A50/TECRA A2 Maintenance Manual (960-478)