User Guide

4 Replacement Procedures 4.9 Switch Board
4-30 Satellite A50/TECRA A2 Maintenance Manual (960-478)
Installing the Switch board
The following describes the procedure for installing the switch board (See Figure 4-20).
1. Connect the switch board cable to the connector PJ3280 on the switch board.
2. Place the switch board to the left side of the installation position and slide it to the
right to install. Then fix it with the following screw.
• M2.5x2.8B THIN BIND screw x1
3. Connect the switch board cable to the connector PJ3200 on the system board.