User Guide

4 Replacement Procedures 4.3 Memory Module
4. Open the left and right latches and remove the memory module.
SLOT A: Standard Memory
SLOT B: Expansion Memory
Latch
Latch
Memory Module
Figure 4-4 Removing Memory Module
Installing the memory module
Before installing the memory module, confirm that the computer is in boot mode. Then
perform the following procedure (See Figure 4-3, 4-4).
1. Insert the memory module into the connector of the computer slantwise (terminal
side first) and press it to connect firmly.
CAUTION:The power must be turned off when you insert a memory module. Inserting a
memory module with the power on might damage the module or the computer
itself.
When installing only one memory module, install it SLOT A. Otherwise, it
might damage the module or the computer itself
Never press hard or bend the memory module.
2. Install the memory slot cover from the front side edge and secure it with the supplied
screw.
3. When the power of the computer is turned on, the computer checks automatically the
memory size. Confirm that the new memory is detected correctly.
4. If the memory is not detected, make sure it is connected surely.
4-12 Satellite A50/TECRA A2 Maintenance Manual (960-478)