User Guide

3.19 Wireless LAN Test (Atheros) 3 chTests and Diagnostics
#######################################################################
######### Askey/Atheros Wireless LAN Module Maintenance T&D #######
#######################################################################
* *
* 1 ..... DUT mode *
* *
* 2 ..... REF mode (Responder) *
* *
***********************************************************************
....Press test number [1,2] ?
Press 1 and Enter of the tester machine. The test program starts and shows the
destination code of the installed wireless LAN card.
Check the "SKU" (destination code). When the code is correct (a proper card is installed),
press any key to continue the test. If the code is not correct (an improper card is
installed), end the test by pressing Ctrl + C.
Example) Message for G86C0000S210 (11a/g: MoW)
********************************************
* *
* Module : Askey/Atheros 802.11a/g *
* *
* SKU : MoW *
* *
* G code : G86C0000S210 *
* *
********************************************
When the test is continued, “Mac Address check” and “Communication test (confirmation
of antenna connection)” are automatically conducted in order.
For the 11a/g card, the antenna connection confirmation test and the sending/receiving
data test are conducted in 11a mode, and the sending /receiving data test is successively
conducted in 11g mode and 11b mode. For the 11g card, the antenna connection
confirmation test and the sending/receiving data test are conducted in 11g mode, and the
sending/receiving data test is conducted in 11b mode.
When the tester machine has passed the test, the message “OK” will appear in the tester
machine.
Press Enter to return to the command prompt.
When the tester machine has not passed the test, it conducts automatically the test again.
When the tester machine still cannot pass the test, the message “NG” will appear in the
tester machine. Pressing Enter on the screen shows the message of the cause of error.
Satellite A50/TECRA A2 Maintenance Manual (960-478) 3-45