User Guide

3.3 Setting of the hardware configuration 3 chTests and Diagnostics
3.3 Setting of the hardware configuration
To execute this program, select 2-Repair initial config test from the
startup menu, press Enter and follow the directions on the screen. The H/W initial
information setting tool consists of four subtests. Move the highlight bar to the subtest
you want to execute and press Enter.
Subtest 01 Initial configuration
This subtest executes the following items and shows their contents in the
display. When an item ends normally, the program proceeds automatically
to the next one. When an error is found, the program stops and waits for
key input. (After solving the problem, the program executes the item
again.) When the DMI information is displayed, the program waits for key
input of DMI information. Then, input the DMI information. For more
details on DMI information, refer to "Subtest 08, DMI write" in the System
test.
Setting of the CPU set table
Setting of the micro code
Inputting or writing of DMI information (RAM, text)
Setting of the HWSC
Setting of the UUID
Display of the DMI information (including UUID)
After completion of the above settings, the DMI information and the H/W
configuration & DMI information are appeared in order. Check the
contents and press Enter.
Subtest 02 Region write
This subtest executes the setting of the region code for DVD drive.
The following message appears in the display. Press any key to return to
the H/W initial information setting tool menu.
##################################
####### It completed ########
##################################
* *
Press any key to continue...
Subtest 08 System configuration display
Satellite A50/TECRA A2 Maintenance Manual (960-478) 3-7