User Guide

4.26 Fluorescent lamp 4 Replacement Procedure
Satellite A40 Maintenance Manual (960-458) 4-91
Attaching the tapes and insulation sheet
1. Attach the PCB insulation sheet (one point).
2. Attach the tape for the bezel to the bottom area close to the lamp (two points).
3. Attach the tape for fixing the FL tube cable (one point).
CAUTION: When attaching tape and insulation sheet, be careful not to damage the TAB
and lamp cable connections.
? ? ? ? ? ? ? ? ? ? ? ? ?? ?? ? ? .
2
1
? ?? ? ? ? ? ? ?
P C B? ? ? ? ? ?
? ?? ? ?? ? .
? ? ? ?? ? ? ? ? ,
? ? ? ? ? ? ? ?? ?
? ? ? ? ? ? ?? ?
1
? ? ? ? ?? ? ? ? ? ? ?
?? ? ? ? ? ?? ? ? ? ?
? ? ?? ? ? ? ? ? ? ? ?
? ? ? ? ? ? ? ?? ? ? ? ?
? ? ? ? ? ? ? ?? ? ? ? ?
? ? ? ? ?? ? ? ? ? ? ?
2
5
? ? ?? ? ?? ?? ?? ? ? ?
?? ? ? ?? :
?? ?? ?? ?? ? ?? ?
? ?? ? :
? ? ?? ? ?? ? ? ? ?
? ?? ? :
Attaching the insulation sheet
Attach the sheet after removing slack.
The frame must not be
overlaid with the PCB.
Align the sheet with the module's edge.
Align the sheet with the reflector's
edge.
Align the sheet with the reflector's edge.
Align the sheet with the module's edge.
The tape edge must not
protrude from the surface
of the module.
The tape edge must not protrude
from the surface of the module.
Attach the sheet by
pressing it so that the
bezel may not "fly".
Attaching the tape for the bezel
Requirements for attachment:
The tape edge must not go
beyond the bezel's edge.
Requirements for attachment:
The tape edge must not go
beyond the module's edge.
Rubber cap:
Must cover the
opening for the cable.
ƒ
Figure 4-74 Replacing 14 Inch TMD fluorescent lamp (12)