User Guide

3 Tests and Diagnostics 3.23 SETUP
3-54 Satellite A40 Maintenance Manual (960-458)
3.23.2 Accessing the SETUP Program
Selecting 0 from the DIAGNOSTICS MENU and pressing Enter displays the SETUP screen.
The SETUP screen is divided into two pages.
NOTE: Panel Power On/Off item appears only when the Power-up Mode is in Resume
mode.
Boot Priority = HDD→FDD→CD-ROM→LAN
HDD Priority = Built-in HDD→PC Card
Network Boot Protocol = PXE
Total = XXXXX KB
MEMORY
Not Registered
Power On Display = Auto-
Selected
LCD Display Stretch = Enabled
Power-up mode = Boot
CPU Cache = Enabled
Level 2 Cache =
Enabled
Dynamic CPU Frequency Mode
= Dynamically Switchable
Hyper-Threading Technology = Enabled
Auto Power On
= Disabled
SYSTEM SETUP (1/2) ACPI BIOS version = X.XX
BOOT PRIORITY
PASSWORD
DISPLAY
Battery Save Mode = Full Power
BATTERY
Others
↑↓→←: Select items Space, BkSp: Change values PgDn, PgUp: Change pages
Esc: Exit without saving Home : Set default values End: Save changes and
Exit
Date(MM-DD-YY) = XX-XX-XXXX
Time(HH:MM:SS) = XX:XX:XX
SYSTEM DATE/TIME
Controller Mode = Auto-Selected Device Config. = Setup by OS
CONFIGURATION
Parallel =
LPT1(378H/IRQ7/CH3)
PCI BUS
=
IRQ10, IRQ11
Built-in HDD
= Primary IDE(1F0H/IRQ14)
CD-ROM = Secondary IDE(170H/IRQ15)
SYSTEM SETUP (2/2) ACPI BIOS version = X.XX
PC CARD
I/O PORTS
DRIVERS I/O
PCI BUS
↑↓→←: Select items Space, BkSp: Change values PgDn, PgUp: Change pages
Esc: Exit without saving Home : Set default values End: Save changes and
Exit
Built
-
in LAN
= Enabled
PCI LAN
USB KB/Mouse Legacy Emulation
= Enabled
USB
-
FDD Legacy Emulation
=
LEGACY EMULATION
Internal Pointing Device = Enabled
Parallel Port Mode = ECP
Hard Disk Mode = Enhanced IDE(Normal)
PERIPHERAL