User Guide

3.2 Executing the Diagnostic Test 3 Tests and Diagnostics
Satellite A40 Maintenance Manual (960-458) 3-3
3.2 Executing the Diagnostic Test
Toshiba MS-DOS is required to run the DIAGNOSTICS TEST PROGRAM. To start the
DIAGNOSTIC TEST PROGRAM, follow these steps:
1. Insert the Diagnostics disk in the floppy disk drive and turn on the computer while pressing
U key.
(The Diagnostics Disk contains the MS-DOS boot files.)
The following menu will appear:
1.Repair Main (T&D)
2.Repair initial config set
Enter a choice = 1
To execute Repair Main (T&D), select “1.Repair Main (T&D)” with ↑ or ↓ key and press
Enter key.
To execute Repair initial config set, select “2.Repair initial config set” with ↑ or ↓ key and
press Enter key.
The followings are described on the Repair Main (T&D). The Repair initial config set is
described in section 3-24.