User Guide

TOSHIBA
Tough Enough for Today’s World
FIELD REPLACEABLE UNIT DOCUMENTATION
5200 Series
SD CARD BOARD REMOVAL
7. Turn the system board upside down.
8. Remove the HDD FPC from PJ105 on the system
board.
9. Disconnect the DC IN jack cable from PJ8800 on
the system board.
1. Peel off the plastic insulator covering the SD card board.
2. Disconnect the sub LCD back light I/F cable from
PJ4001, the sub LCD I/F cable from PJ4002 and the
PAD I/F cable from PJ4003.
3. Remove two M2x4 brass screw securing the
SD card board.
4. Lift out the SD card board.
Satellite
TM
SYSTEM BOARD REMOVAL
5. Remove the Following eleven screws:
- 8 M2.5x4 brass screws
- 2 M2.5x2.8 black flat head screws
- 1 M2.5x14 stud screw
6. Lift out the system board from the left side.
5. Disconnect the SD Card board I/F cable from
PJ4000 on the SD card board.
DC-IN
harness
M2.5x2.8 black flat head screws
PJ8820
M2.5x4 brass screws PJ105
HDD FPC
PJ8800
DC IN jack cable
SD card
board
SD card board I/F cable
PJ4000
Plastic
insulator
SD card
board
Sub LCD
backlight
I/F cable
PJ4001
Sub LCD I/F cable
PJ4002
PAD I/F cable
PJ4003