User Guide

3-32 100CS
3.14 EXPANSION Test
NOTE: To execute this subtest, the PCMCIA wraparound connector is required.
Subtest 01 PCMCIA wraparound (Internal)
This test checks the following signal line of the PCMCIA slot:
❑ Address line
❑ REG#, CE#1, CE#2 line
❑ Data line
❑ Speaker line
❑ Wait line
❑ BSY#, BVD1 line
This subtest is executed in the following order:
Sub# Address Good Bad Contents
01 00001 nn xx Address line
00001 nn xx REG#, CE#1, CE#2
nn=A0, 90, 80, 00
02 00002 ww rr Data line
ww=write data, rr=read data
03 00003 –– –– Speaker line
04 00004 40, 80 xx Wait line (40<xx<80)
05 00005 nn xx Other lines (BSY#, BVD1)
nn=21, 00
Subtest 02 PCMCIA wraparound (External)
This test checks the signal lines of the enhanced port replicator’s PCMCIA
slots.
Procedures for conducting this test are the same as for subtest 01 PCMCIA
wraparound (Internal) described above.