User Guide

100CS 4-25
5. Remove four M2x2 screws securing the frame to the drive and lift off the frame.
6. Disconnect the flexible cable from the drive.
Figure 4-22 Removing the diskette drive frame
Installing the FDD
To install the FDD, follow the steps below and refer to figures 4-21 and 4-22.
1. Connect the flexible cable to the FDD.
2. Secure the frame to the diskette drive with four M2x2 screws .
3. Engage the latches on the frame with corresponding notches on the computer.
4. Seat the diskette drive and secure it with four M2.5x6 screws .
5. Connect the flexible cable to PJ5 on the system board.
6. Install the membrane switch, top cover and display assembly, sub-battery and VGA
assembly, keyboard, HDD, optional memory module, optional PC card, and
battery pack as described in sections 4.9 back through 4.2.