Use and Care Manual

Page 30 User Manual
Installation
Instructions
11 INSTALL WEATHER STRIPPING (only be
applicable to Energy star models)
In order to minimize air leaks between the room
air conditoner and the window opening, trim
the weather sttipping with a proper length, peel
o the protective backing and plug any gaps if
needed (Fig. 23).
1 Select Wall Location
The air conditioner has a slide-out chassis, so that it can be installed through an outside wall as
specified below:
Max. Wall thickness: 12 in or 10 in
IMPORTANT: Side louvers must never be blocked.
Fig. 23
NOTE
Consult local building codes prior to installation, or a qualified carpenter.
NOTE
All parts needed for Thru-The-Wall Installtion are provided, except a wood frame, shims, and 10 wood
screws (#10-1 in long minimum).
Select a wall surface that:
1. Does not support major structural loads such as the frame construction at ends of windows, and
under truss-bearing points, etc.
2. Does not have plumbing or wiring inside.
3. Is near existing electrical outlets, or where another outlet can be installed.
4. Faces, and is not blocked to the area to be cooled.
5. Allows unblocked air ow from rear sides and end (outside) of installed air conditioner.
B. Thru-the Wall Installation