User Guide

2 Troubleshooting Procedures 2.4 System Board Troubleshooting
Table 2-6 Debug port (Resume mode) error status (2/4)
LED Status Test item Contents
(F122h)
Initializing of sound
Acquires the multi-box status.
Initializing of HC, recognizing of USB devices
connection and initializing the USB devices
Control of permission/prohibition for built-in LAN
Check of the checksum of conventional
memory
Resume error DPORT=F174H
Initializing of PCI devices
F123h
Check of WakeUp factors after initializing
PCI bus
Waiting for initializing of devices which
have to be initialized before setting HW
by PnP resource
Processing of RESUME for PnP
Waiting for the completion of VGA power-down
control (because the VGA configuration can not
be seen)
Processing of RESUME for PCI
Checks slots that were in ON status during
suspending ( for fingerprint identification)
Recovery of PCMCIA card
Error when an ATA card is pulled out
Resume error DPORT=17BH
Recovery of each device (1)
Executing of dividing process of device detection
of PC card
Check of HDD pack connection
Resume error when HDD is mounted
DPORT=F172h
F124h
Start of IDE device resume sequence
Recovery of user alarm setting and
cancel of alarm power-on function
(only one time)
Enable of power-off switch
F125h
Initializing EC and start of reading battery
information
QOSMIO G10 Maintenance Manual (960-497) 2-33