User Guide

4 Replacement Procedures 4.28 LCD harness
Installing the LCD harness
The following describes the procedure for installing the LCD harness (See Figure 4-56).
1. Arrange the LCD harness along the guide.
2. Install the LCD harness holder (display cover side) and secure it with the following
screw.
• M2.5×4.0B FLAT BIND screw x1
3. Install the LCD support (display cover side) and secure it with the following screws.
• M2.5×6.0 PSP TIGHT screw x2
4. Install the LCD cushion on the LCD support.
NOTE: When installing the LCD cushion, make sure that the edge of LCD cushion is fit
on the edge of LCD support.
Fit the edges
QOSMIO G10 Maintenance Manual (960-497) 4-79