User Guide

4 Replacement Procedures 4.25 TV tuner module
4.25 TV tuner module
Removing the TV tuner module
The following describes the procedure for removing the TV tuner module (See Figure 4-48
and 4-49).
1. Disconnect the USB harness from the connector CN4613 on the system board and
pull it out from the harness guide.
2. Disconnect the TJ board cable from the connector CN5660 on the system board and
pull it out from the harness guide.
3. Disconnect the TV tuner harness from the connector CN5661 on the system board
and pull it out from the harness guide.
4. Remove the following screws securing the harness guide and TV tuner module.
• M2.0×6.0Z BIND screw x2
5. Remove the harness guide.
M2.0x6.0Z BIND
CN5660
TJ board cable
Harness guide
USB harness
CN4613
TV tuner harness
CN5661
Figure 4-48 Removing the harnesses guide
QOSMIO G10 Maintenance Manual (960-497) 4-69