User Guide

4.20 System board 4 Replacement Procedures
Installing the system board
The following describes the procedure for installing the system board (See Figure 4-41).
1. Fitting the PC card eject button, install the system board to the base assembly from
the PC card side first.
2. Turning up the insulator (covering on 1 screw hole), secure the system board with
the following screws.
• M2.5×4.0B FLAT BIND screw x3
3. Connect the speaker (L) cable to the connector CN6002 on the system board.
4-62 QOSMIO G10 Maintenance Manual (960-497)