User Guide

4 Replacement Procedures 4.19 Speaker (R) / TJ board
4.19.2 TJ board
Removing the TJ board
The following describes the procedure for removing the TJ board (See Figure 4-40).
1. Disconnect the TV antenna cable from the connector CN9611 on the TJ board and
pull it out from the guide of base assembly.
2. Remove the following screws securing TJ board and remove the TJ board.
• M2.5×4.0B FLAT BIND screw x2
CN9611
TV antenna cable
M2.5x4.0B FLAT BIND
TJ board
TV antenna cable
Figure 4-40 Removing the TJ board
QOSMIO G10 Maintenance Manual (960-497) 4-59