User Guide

4.19 Speaker (R) / TJ board 4 Replacement Procedures
4. Pull out the USB harness from the guide of base assembly.
5. Disconnect the TJ board cable from the connector CN9614 on the TJ board and pull
it out from the guide of base assembly.
6. Disconnect the speaker (R) cable from the connector CN6003 on the system board
and pull it out from the guide.
7. Pull up the speaker (R) straight and remove it.
Speaker (R) cable
Speaker (R)
Guide
CN9614
TJ board cable
CN6003
USB harness
Figure 4-38 Removing the speaker (R)
4-56 QOSMIO G10 Maintenance Manual (960-497)