User Guide

4 Replacement Procedures 4.19 Speaker (R) / TJ board
4.19 Speaker (R) / TJ board
4.19.1 Speaker (R)
Removing the speaker (R)
The following describes the procedure for removing the speaker (R) (See Figure 4-37 and 4-
38).
1. Peeling off the glass tape from the harness holder.
2. Pull out the DC-IN jack from the slot and pull out the DC-IN cable from the guide
of harness holder.
3. Remove the following screw securing the harness holder and remove the harness
holder.
• M2.5×4.0B FLAT BIND screw x1
Glass tape
M2.5x4.0B FLAT BIND
DC-IN jack
DC-IN cable
guide
Harness holder
Figure 4-37 Removing the harness holder
QOSMIO G10 Maintenance Manual (960-497) 4-55