User Guide

4 Replacement Procedures 4.16 RTC battery / BT board
4.16.2 BT board
Removing the BT board
The following describes the procedure for removing the BT board (See Figure 4-34).
1. Remove the following screw securing the battery connector cover and remove the
battery connector cover.
• M2.5×6.0B FLAT BIND screw x1
2. Disconnect the BT board flat cable from the connector CN9691 on the BT board
and from the connector CN8021 on the system board.
3. Remove the following screw securing the BT board.
• M2.5×6.0B FLAT BIND screw x1
4. Disconnect the battery harness from the connector CN9690 on the BT board and
from the connector CN8020 on the system board.
Batter
y
connector cover
CN9690
Batter
y
harness
M2.5x6.0B FLAT BIND
BT board flat cable
M2.5x6.0B FLAT BIND
CN8021
CN9691
CN8020
BT board
Figure 4-34 Removing the BT board
QOSMIO G10 Maintenance Manual (960-497) 4-51