User Guide

4.13 SD board / Microphone / MDC 4 Replacement Procedures
4.13.3 MDC
Removing a MDC
The following describes the procedure for removing a MDC (See Figure 4-30).
1. Remove the following screws securing a MDC.
• M2.0×4.0Z BIND screw x2
2. Pull up straight and remove a MDC from the connector CN3000 on the SD board.
3. Disconnect the MDC harness from a MDC.
M2.0x4.0Z BIND
MDC
MDC harness
CN3000
Figure 4-30 Removing a MDC
Installing a MDC
The following describes the procedure for installing a MDC (See Figure 4-30).
1. Connect the MDC harness to the connector on the MDC.
2. Connect and install a MDC to the connector CN3000 on the SD board.
3. Secure a MDC with the following screws.
• M2.0×4.0Z BIND screw x2
4-46 QOSMIO G10 Maintenance Manual (960-497)