User Guide

4 Replacement Procedures 4.13 SD board / Microphone / MDC

4.13.2 Microphone

Removing the microphone

The following describes the procedure for removing the microphone (See Figure 4-29).

1. Disconnect the mic cable from the connector CN6000 on the SD board.

2. Pull out the microphone from the mic hold guide.

Microphone

CN6000

Mic hold

uide

Figure 4-29 Removing the microphone

Installing the microphone

The following describes the procedure for installing the microphone (See Figure 4-29).

1. Install the microphone to the mic hold guide.

2. Connect the mic cable to the connector CN6000 on the SD board.

QOSMIO G10 Maintenance Manual (960-497) 4-45