User Guide

4 Replacement Procedures 4.13 SD board / Microphone / MDC
4. Remove the following screws securing the mic assembly and peel off the insulator
fixing the SD board.
• M2.0×4.0Z BIND screw x1
5. Pulling out the SD board flat cable from the slot of cover assembly, remove the SD
board from the cover assembly with the mic assembly connected.
6. Turning over the SD board, disconnect the SD board flat cable from the connector
CN9510 on the system board.
M2.0x4.0Z FLAT BIND
CN9510
SD board flat cable
SD board
Slot
Insulator
Insulator
SD board flat cable
Figure 4-28 Removing the SD board
QOSMIO G10 Maintenance Manual (960-497) 4-43