User Guide

4.8 Switch membrane 4 Replacement Procedures
4.8 Switch membrane
Removing the switch membrane
The following describes the procedure for removing the switch membrane (See Figure 4-12).
1. Turning up the insulator, disconnect the switch membrane from the connector
CN9650 on the system board.
2. Remove the following screw securing the switch membrane.
• M2.5×2.8B FLAT BIND screw x1
3. Slide the switch membrane to the arrow direction and remove it.
CN9650
Switch membrane
M2.5x2.8B FLAT BIND
Insulator
Figure 4-12 Removing the switch membrane
4-24 QOSMIO G10 Maintenance Manual (960-497)