User Guide

4.4 HDD 4 Replacement Procedures
4.4 HDD
Removing a HDD
The following describes the procedure for removing a HDD (See Figure 4-4 to 4-6).
CAUTION: Take care not to press on the top or bottom of a HDD. Pressure may cause
data loss or damage to the device.
1. Turn the computer upside down.
2. Remove the following screws securing a HDD slot cover and remove a HDD slot
cover.
• M2.5×4.0B FLAT BIND screw x3
3. Remove the following screws securing the 1st HDD assembly.
• M2.5×6.0B FLAT BIND screw x１
4. Disconnect the 1st HDD assembly from the connector on the system board CN1880.
CAUTION: When a 2nd HDD is installed, they are installed in the position as the
following figure.
1st HDD
CN1800
CN1880
2nd HDD
4-12 QOSMIO G10 Maintenance Manual (960-497)