User Guide

3 Tests and Diagnostics 3.20 ONLY ONE TEST
Slide the switch to OFF position. Then, following message appears in the
display.
KILL SWITCH ON !!
Slide the switch to ON position. Then, following message appears in the
display.
KILL SWITCH OFF !!
After Sliding the switch to OFF position, return to the ONLY ONE TEST
menu automatically.
Subtest 05 USB
NOTE: When executing this subtest, USB test module and USB cable must be
connected.
This subtest checks if USB port works properly.
The following menu appears in the display.
#################################################################
######## ONLY ONE TEST Menu (XXXXXXXXX) #######
#################################################################
* *
* 0 ............ Port 0 *
* 1 ............ Port 1 *
* 2 ............ Port 2 *
* 3 ............ Port 3 *
* 9 ............ EXIT *
* *
*****************************************************************
.... Press test number[0-3, 9] ?
Connect the USB test module and USB cable to the computer.
Input the port test number and press Enter.
OK message appears in the display if the test ends without a defective.
NG message appears in the display if a defective is found during the test.
Confirm the connection of cable, then execute the test again.
Press 9 and return to ONLY ONE TESST menu.
QOSMIO G10 Maintenance Manual (960-497) 3-43