Full Product Manual

User Manual Page 9
Operating
Instructions
Control Panel Features
Swing Button
Used to initiate the Auto Swing feature. When the
operation is ON, pressing the SWING button can
stop the louver at the desired angle.
Connect Button (Smart models only)
Also used to initiate the wireless connection mode.
To initiate the wireless connection mode, power on
the air conditioner then press the SWING button
for 3 seconds. The LED DISPLAY will show ‘AP’ to
indicate the unit is in wireless connection mode.
Refer to the app connection instructions to nish
the connection process.
If the connection is successful, the unit will exit
wireless connection mode and illuminate the
wireless LED. If the connection fails, the unit will
exit wireless connection mode automatically after 8
minutes and the wireless LED does not illuminate.
Note: The wireless connection process must be
completed within 8 m
inutes after powering the air
conditioner on.
Timer button
Used to initiate the AUTO ON start time and AUTO
OFF stop time program. T light will
illuminate depending on the selected setting.
Fan button
Controls the fan speed. Press to control the fan speed in
four steps - LOW, MID, HIGH and AUTO. The selected fan
speed light (except AUTO) will illuminate. When AUTO is
selected, no lights will illuminate.
NOTE: Applicable to models with the Constant Fan
feature. In COOL or DRY mode, press the Fan button for
the constant fan function.
When the function is turned on, the constant fan
light will illuminate, identifying the fan continuous
,
the constant fan light will go out, identifying the
fan cycle run with compressor stop.
Mode button
Selects the desired operating mode. Each time
you press the button, a mode is selected in a
sequence that goes from AUTO, COOL, DRY,
FAN and HEAT (cooling only models excluded).
The mode light illuminates and indicates the
selected mode. To change between °F or °C,
simultaneously press and hold the Up and
Down buttons for 3 seconds.
Up ( ) and Down ( ) buttons
Used to increase/decrease temperature
settings in 1°F (or 2°F)/1°C increments in a
range of 62°F/17°C to 86°F/30°C or the TIMER
setting in a range of 0 ~ 24hrs.
To change between °F or °C, simultaneously
press and hold the Up and Down buttons for
3 seconds.
Power button
Power switch on/o.
Sleep button
Used to initiate the SLEEP operation.
LED display
Shows the set temperature in °F (Degrees
Fahrenheit) or °C (Degrees Celsius) and the
Auto-timer settings. While on DRY and FAN
modes, it shows the room temperature.
Timer
Button
Swing
Button
Power
Button
Sleep
Button
Fan
Button
Up (
) and Down ( )
Buttons
Mode
Button
LED WIRELESS (SMART
MODELS ONLY)
DisplayMyTemp function
Heat Mode Indicator Light
(only for heat model)
MyTemp
HEAT
3 seconds