Maintenance Manual

4 Replacement Procedures 4.18 Fluorescent Lamp

4. Stick the outside tape and install the cover shield.

1) Stick the tape shield and adhesive tape to fix the top case.

NOTE: Be careful not to apply excessive force to the top case.

2) Install the cover shield (C).

NOTE: Be careful not to apply excessive force to the control PCB.

CAUTION: Wear anti-static gloves to prevent circuit damage to the source

PCB.

3) Install the cover shield (G).

NOTE: Be careful not to apply excessive force to the gate TCP.

4) Stick the adhesive tape to fix the B/L wire.

NOTE: Be careful not to apply excessive force to the B/L wire.

Cover shield (C)

Tape shield

dhesive tape

Cover shield (G)

dhesive tape

Figure 4-97 Replacing 15.0 Inch LG.Philips fluorescent lamp (XGA) (8)

4-106 Satellite A10/TECRA A1/Satellite Pro A10 Maintenance Manual (960-445)