User Guide

File No. 960-140
3-42
3.18.2 Operations
NOTE: After the HDD has been formatted, execute the Toshiba MS-DOS FDISK
command to partition the HDD. Execute the Toshiba MS-DOS FORMAT command. Refer
to the Toshiba MS-DOS manual for more information about using these commands.
Selecting TEST 2 and pressing Enter in the DIAGNOSTIC MENU, displays the following
messages:
DIAGNOSTICS - HARD DISK FORMAT : VX.XX
1 - All track FORMAT
2 - Good track FORMAT
3 - Bad track FORMAT
4 - Bad track CHECK
9 - Go to TEST MENU
↑↓→← : Select items, Enter: Finish, Esc: Exit
1. All Track FORMAT
Pressing 1 selects All track FORMAT, which lets you format the entire disk.
[All track FORMAT]
Drive: #1 = HDD #2 = Non
Cylinder : XXXX
Head: XX
Sector: XX
<<< Model name = >>>
The following selections also appear at the bottom of the screen in succession:
Drive number select (1 :#1,2:#2) ?
(a) Select a drive number and press Enter. The following message will appear:
Interleave number (1/1 ~ 8 ) ?
(b) Select an interleave number, 1 ~ 8 and press Enter. Pressing only Enter
selects 1.