Automobile Parts User Manual

− 59 −
6 F 8 A 0 9 3 4
Switch operation Display example Description
STEP1
FLOW DIR
NORMAL
The currently set flow direction (NORMAL
in this example) appears.
Then push .
* Pushing returns you to the setting
menu.
STEP2
FLOW DIR
NORMAL
The switches at the bottom change.
( are shown.)
At the same time, the cursor appears.
(The item indicated by the cursor is
highlighted.)
Then push .
STEP3
FLOW DIR
SWITCH
You can continue to change the setting item.
Pushing changes the selection
items.
: Selected item is scrolled up.
: Selected item is scrolled down.
STEP4
FLOW DIR
SWITCH
Perform this operation to change the setting
to SWITCH.
When the desired item is obtained, push
to set the item temporarily.
STEP5(=END)
FLOW DIR
SWITCH
SET OK?
Pushing shows a message to confirm
whether the setting is OK or not.
If OK, push . If you need to redo the
setting, push .
Pushing cancel the setting operation
and exits the setting screen.
8.2.6 Display Setting
You can select one of the engineering units listed below as a flow measurement unit.
Flow velocity unit
m/s, ft/s
Flow rate unit
(Note3)
m
3
/s, m
3
/min, m
3
/h, m
3
/d , L/s, L/min, L/h, L/d,
mL/s, mL/min, mL/h, mL/d, gal/s, gal/min, gal/h, gal/d,
bbl/s, bbl/min, bbl/h, bbl/d, pt/s, pt/min, pt/h, pt/d,
qt/s, qt/min, qt/h, qt/d
ft
3
/s, ft
3
/min, ft
3
/h, ft
3
/d, Mgl/s, Mgl/min, Mgl/h, Mgl/d
Volume unit
m
3
, L , mL , gal , bbl , pt , qt, ft
3
, Mgl
Other units
% , COUNT , RANGE , GRAPH , CUSTOM
Totalized flow direction
Forward direction (when F or B is selected)
Reverse direction (when R or B is selected)
Totalized difference flow
Difference between totalized forward flow and totalized
reverse flow (when totalized flow direction D is selected)
Note 1: If COUNT, RANGE, GRAPH or CUSTOM is selected, the display is shown below:
ESC
ESC
O K
N O
N O
O K
ESC
ESC