Automobile Parts User Manual

− 90 −
6 F 8 A 0 9 3 4
Switch operation
Display example
Description
STEP2
OUT MODE
HOLD
The switches at the bottom change.
( are shown.)
At the same time, the cursor appears.
(The item indicated by the cursor is
highlighted.)
Then push .
STEP3
OUT MODE
50ms PLS
You can continue to change the setting item.
Push to change the selection
items.
: Selected item is scrolled up.
: Selected item is scrolled down.
When the desired item is selected, push
to set the item temporarily.
STEP4(=END)
OUT MODE
50ms PLS
SET OK?
When you push , a message appears
to confirm whether the setting is OK or not.
If OK, push . If you want to redo the
setting, push .
Pushing cancels the setting operation
and exits the setting screen.
8.2.23 Flow Rate High/Low Alarm and High-High/Low-Low Alarm
The high/low limit, high-high/low-low limit of the flow rate, at which an alarm is generated, can be set
as % value of the span flow rate of the set maximum range.
The high/low alarm, and high-high/low-low alarm values for flow rate can be set within the range of
−10% to 110% (percentage to Range 1) in increments of 0.1%.
●Changing the high/low alarm on/off setting
The following is an example to change the high alarm setting from OFF to ON.
Switch operation
Display example
Description
L:H/L ALM1
1 H SET
2 H VAL
3 L SET
4 L VAL
5 EXIT
Select "H SET" from the setting item
selection menu.
STEP1
H SET
OFF
The current setting (OFF in this example)
appears.
Then push .
* Pushing returns you to the menu
screen.
N O
O K
ESC
O K
N O
ESC
ESC
ESC
ESC