Automobile Parts User Manual

− 86 −
6 F 8 A 0 9 3 4
You can check or change the count rate and pulse width as described below.
The following is an example to change the count rate from 0.01m
3
to 0.9 L.
Switch operation
Display example
Description
STEP1
CNT RATE
0.01000
m
3
The currently set count rate (0.01m
3
in this
example) appears.
Then push .
STEP2
CNT RATE
0.01000
m
3
The switches at the bottom change.
( are shown.)
At the same time, the cursor appears.
STEP3
CNT RATE
10.0000
L
Push to move the cursor to the digit
of the unit and push to change from
“m
3
” to “L”.
STEP4
CNT RATE
0.90000
L
Push to move the cursor to the digit
you want to change and push to
change the number of the digit.
STEP4(=END)
CNT RATE
0.90000
L
SET OK?
When you push , a message appears
to confirm whether the setting is OK or not.
If OK, push . If you want to redo the
setting, push .
Pushing cancels the setting operation
and exits the setting screen.
To set the pulse width setting mode or pulse width, select the relevant item below from the setting
menu.
Pulse width setting mode PLS MODE
Pulse width PLS WID
ESC
N O
O K
ESC
O K
N O
ESC