Automobile Parts User Manual

− 62 −
6 F 8 A 0 9 3 4
For example, if the setting range is 10m/s and display digit setting is 1/100, the measured value will
be displayed to the first decimal place.
Setting range＝１０．００００ ｍ／ｓ
Likewise, when the setting range 1m/s and display digit setting is 1/100, the measured value will be
displayed to the second decimal place.
The numbers less than the displayed digits will be rounded.
Note: The maximum display digits for flow velocity, flow rate and custom value are 7 digits.
If the measured value exceeds 7 digits, the displayed value remains fixed at the maximum display
value.
● Changing the totalized flow volume direction
You can change the totalized flow volume direction as described below.
The following is an example to change the Display 1 setting from Fixed forward totalized flow (F)
to Bidirectional flow (B).
Switch operation
Display example
Description
DSPL1
m
3
F
Select "DSPL1" from the setting item
selection menu.
The currently set display setting (m
3
F in
this example) appears.
Then push .
STEP1
DSPL1
m
3
F
The switches at the bottom change.
( are shown.)
At the same time, the cursor appears.
STEP2
DSPL1
m
3
B
Push to move the cursor to the
third unit (totalized flow direction) and then
push to change the direction.
Then push to set the display unit
temporarily.
STEP3(=END)
DSPL1
m
3
B
SET OK?
Pushing shows a message to confirm
whether the setting is OK or not.
If OK, push . If you need to redo the
setting, push .
Pushing cancel the setting operation
and exits the setting screen.
Maximum effective digits
One hundredth of
maximum effective digits
ESC
N O
O K
ESC
O K
N O
ESC