User's Manual

GC-4030 Page 4/10 2019/6/19
20 cm minimum distance has to be able to be maintained between the antenna and the users for the host
this module is integrated into. Under such configuration, the FCC radiation exposure limits set forth for an
population/uncontrolled environment can be satisfied.
Any changes or modifications not expressly approved by the manufacturer could void the user's authority
to operate this equipment.
USERS MANUAL OF THE END PRODUCT:
In the user’s manual of the end product, the end user has to be informed to keep at least 20 cm separation
with the antenna while this end product is installed and operated. The end user has to be informed that
the FCC radio frequency exposure guidelines for an uncontrolled environment can be satisfied. The end
user has to also be informed that any changes or modifications not expressly approved by the
manufacturer could void the user's authority to operate this equipment. If the size of the end product is
smaller than 8x10cm, then additional FCC part 15.19 statement is required to be available in the user’s
manual: This device complies with Part 15 of FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference and (2) this device must accept any
interference received, including interference that may cause undesired operation.
LABEL OF THE END PRODUCT:
The final end product must be labeled in a visible area with the following " Contains FCC ID: BJI-GN4030".
If the size of the end product is larger than 8x10cm, then the following FCC part 15.19 statement has to
also be available on the label: This device complies with Part 15 of FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference and (2) this device must
accept any interference received, including interference that may cause undesired operation.
OEM Integrator Checklist
The party below will implement the LITE-ON Module in host systems in accordance with the instructions
specified in this document and the documents referenced herein.
1.The OEM integrator will ensure the Module is integrated in a host systems using only the approved
antenna model(s) described in this document.
2.The OEM integrator will ensure the antenna placement inside the host system willmaintain the required
spacing to end user for RF Exposure compliance, as specified in this document. 3.If other radios are
integrated inside the host with the LITE-ON Module, the OEM integrator will contact its test lab, TCB or
LITE-ON to determine if additional FCC compliance evaluation is required to meet FCC collocation rules.
4.The OEM integrator will ensure end user documentation will contain the specified regulatory wording
and ensure the host system and the Module itself are labeled as specified in this document.
5. The OEM integrator will ensure the Module is programmed in the factory with compliant transmit
power not exceeding the levels specified in this document. LITE-ON requests that the OEM integrator
acknowledge its receipt of this document and the above instructions. You may contact LITE-ON with any