Spec Sheet

Toshiba America Information Systems, Inc. Imaging Systems Division

9740 Irvine Boulevard, Irvine, California 92618 = 1-877-855-1349 = www.ipvideo.toshiba.com

2006 Toshiba American Information Systems, Inc.

All specifications are subject to change.

Made for Toshiba by BATKO

Installation Steps

** Do not immediately remove the plastic film on the lower dome section. Install the Wall Mount (FSM3610) or

Ceiling Mount (FSP3610). Make sure it is safely secured in place.

a) Use a SLOT screwdriver, release the four screws holding the lower dome to the upper dome section (see #1).

IMPORTANT: 1/4 turn counter-clockwise to unlock each screw (1).

Carefully remove the dome cover (use a light twisting movement if needed to loosen seal).

b) Attach the upper dome section to the mounting bracket (2).

c) Remove the mounting plate (3). Pull cables through the mounting bracket (4). Fix the camera to the mounting plate with

the 4 screws provided (5).

d) Connect the 24VAC power cable to the "AC IN" terminals (6). Insure that the transformer isn't connected to the 120VAC

source at this time (input: 24VAC, 100VA).

e) Connect the jumper cable (12VDC) to the camera (7).

f) Insert the mounting plate & camera assembly in LOCATION # 7 inside the dome (8).

NOTE: While installing the mounting plate back in the dome, you may have to move the adapter to level the mounting plate (9).

g) Check all connections before connecting the transformer to 120VAC. If the camera doesn't work, verify the fuse (10) and the

transformer output ! Complete camera testing.

h) Fix the dome cover back in place arrow above arrow (11) and secure the four screws. IMPORTANT: 1/4 turn clockwise

to lock each screw (12). Remove the protective film off the dome cover.

Heater Board

Power Supply

FB-3610-92-HB-C

Outdoor Dome for IK-WB21A

Mounting plate

LOCATION #7

1/4