Instruction Manual

Partitioning and formatting the new drive
Before you can use the new drive, it must be partitioned and formatted. Follow the instructions
provided by the manufacturer.
Take care not toaccidentally format your existing drive. Formatting destroys all data onadrive.
Expansion cards
The 3100Series computer has three PCI card slots for additional components.
IRQ setup
Set an appropriate IRQ level for the expansion card. See "Interrupt levels".
For the setup procedures, see "System Setup Utility (SSU)" and the manuals for the individual
expansion cards. Toshiba recommends that you record the settings in the Device Log in case you
need tochange them when you install other devices. For more information, see "Device Log".
Hardware devices use certain address settings and configuration values touniquely identify them
in the computer. Toeliminate potential hardware conflicts:
• Keep achecklist of all devices and their settings.
• Make sure the device you are adding is compatible with your Microsoft operating system.
• Request the latest 32-bit drivers from your device vendor.
Installing acard
Use caution when installing or removing expansion cards. Protect your hands from possible inju-
ries caused by sharp projections onthe boards and the computer.
Do not touch any parts except those necessary for installing the device. There are many high-
voltage parts that are dangerous totouch.
To install an expansion card:
1.Shut down the computer, set the AC switch onthe back of the computer toOFF, and unplug
the power cable.
2.Remove the side panel. For more information, see "Opening the case".
3.Locate and remove the I/O slot cover onthe rear of the cabinet.
4.Install the expansion card into the desired expansion slot. Be careful not tocatch the card
onthe slot's top and bottom tabs.
5.Secure the expansion card in place by using the screw from the I/Oslot cover.
6.Connect any cabling necessary for the operation of the expansion card.
7.Replace the case.
8.Plug in the power cable and turn onthe computer.
9.Follow the manufacturer's instructions for setting up the expansion card.
Jumper settings onthe card or in the computer BIOS may have tobe changed. Some expansion
cards may also need tobe set up using avendor- supplied setup diskette.