Instruction Manual

Setting the
voltage selector
q To operate the computer in the United States, make sure the voltage switch is set
to115VAC.
q To operate the computer in acountry that uses 220/240 VAC, make sure the voltage switch
is set to230VAC (the left position as you face the back of the computer).
Failure toset the voltage switch correctly will permanently damage the computer's electronics
when you turn onthe computer.
Consult your monitor's documentation tosee if its voltage setting is autoswitchable. If not, it will
require avoltage converter and aplugadapter.
Connecting ACpower
1.Plug the AC power cable into the computer's power socket.
2.Connect the power cable toalive wall outlet.
3.Connect the monitor power cable toalive wall outlet.
Turning onthe computer
1.Check that the diskette and CD-ROM drives are empty.
2.If you have aprinter connected tothe computer, turn onthe printer and wait until there is
indication that the printer is ready (on line).
3.Locate the power button and turn onthe computer.
The indicator light glows when the computer is on.
When you turn onthe computer for the first time, donot turn off the power again until the
operating system has loaded completely.
The hard disk drive light indicates that the hard disk drive is currently in use.
Do not turn off the computer if any of the drives are in use.