Instruction Manual

Adding other components
Install any additional components or accessories at this time.
Adding memory
Your computer comes with enough memory torun most popular applications. With additional
memory, the computer:
q Can run more programs and open more documents at the sametime.
q Will run applications faster.
Additional memory is available from your dealer in the form of modules that fit inside the
computer.
Connecting toapower source
Before connecting your computer toapower source, read the following sections.
Power precautions
The following suggestions help prevent injury toyou or damage tothe computer.
q Do not plug in AC power cables until you have connected all the system components.
q Always plug power cables into grounded outlets.
q Never connect or disconnect components with the power on.
q Use apower filter/ surge protector (not included) for AC power connections toyour system
and any phone/ modem connections.
q In the event of asevere electrical storm, disconnect all the power cables and the telephone
cable.
q The system is configured for European standard 220V/240V 50Hz power. Before
connecting toalower voltage source (110V/120V 60Hz AC), refer tothe next section.
q Do not modify, forcibly bend, damage, place heavy objects ontop of, or apply heat tothe
power cable. The cable may otherwise become damaged, resulting in fire or electric shock.
q If the power cable becomes damaged or the plug overheats, discontinue use. There is
apossibility of fire or electric shock.
q Do not pull directly onthe power cable when removing the power plug from the power
source. Hold the power plug when removing the cable from the outlet.
q Do not remove the power plug with wet hands. This may cause an electric shock.
Setting the voltage switch
Computers purchased in Europe are configured for 230VAC operation. Computers purchased in
the United States or other countries may be set to110/120 VAC. Tooperate the computer in
acountry that uses adifferent voltage than the country of purchase, you must change the voltage
selection and use aplug adapter. The voltage selection switch is onthe back panel.
To change the voltage selection, insert the tip of apen into one of the holes onthe switch, then
slide the switch tothe correct setting.