User Guide

EOl-19002
DRWST-53 SERIES
5. HOW TO FIX DRAWER IN PLACE ON THE TERMINAL
To attach the drawer (DRWST-53) to the ST-4500 terminal and use this terminal as an integrated terminal,
follow the procedure below.
1) Remove the top cover and the control unit from the ST-4500 terminal.
Double Sems
Double Sems Screw (M3x8)
2) Remove the cable holder that is attached to the rear of the bottom of the drawer. Place the excessive cable
in the area where the cable holder has been detached, excluding 25cm from the top of the drawer cable.
Then, reattach the cable holder.
Drawer
P \
, Cable Holder
Cable
-4-