User manual

21
(12) DNR = Digital noise reduction
Move the cursor to the position shown in fig.
Use the ▲ ▼ SELECT switches to select LOW,
HIGH, SUPER.
LOW : Standard position.
HIGH : Increase the effect of DNR.
SUPER : Further increase the effect of DNR.
NOTE
• If you set HIGH or SUPER the noise
reduction effect is reduced but an
after-image is produced if a moving
subject is shot.
(13) HI-RESO = Hi resolution
Move the cursor to the position shown in fig.
Use the ▲ ▼ SELECT switches to select OFF
or ON in the HI-RESO setting.
OFF : Standard position.
Resolution of horizontal is 480TV lines
or more.
ON : Hi resolution function is activated.
Resolution of horizontal is 520 TV
lines.
NOTE
• If you set HI-RESO to ON, the image signal resolution is increased, but de-
pending on the subject, noise may be increased.
ID
....................
ID-POS OFF
PTN - GEN OFF
AWB - R N G S T D
DNR LOW
HI -RESO OFF
BACK
EX I T CANCEL DE FAULT
ID
....................
ID-POS OFF
PTN - GEN OFF
AWB - R N G S T D
DNR LOW
HI -RESO OFF
BACK
EX I T CANCEL DE FAULT