Instruction Manual

Press [ENTER].

"To Standby Mode" is highlighted.

Press [ENTER] again.

In a second, the unit will be turned off

automatically as it goes into the satellite link

standby mode.

To cancel the satellite link function while in

the satellite link standby mode:

Press [TIMER SET] to turn on the unit.

To cancel the satellite link function while the

satellite link recording is in progress:

Press [BSTOP] or EJECT /■ STOP] on the

front panel of the unit.

Note I

i • If the signal of external input breaks up over 5 seconds, satellite link function will be canceled. |

• If you have not set the clock, "Clock Setting" menu will appear at step 1. Follow to step 3 in "Clock Setting" on |

I page 26. ■' '' V■ ■':■

J • You cannot set the end time for the satellite link timer recording on this unit. . |

• Recording picture will be distorted if the copy protection signal is being detected during satellite link timer |

recording.

• You can record the satellite link by using S-video input jacks on the rear panel. Refer to page 19 for more

i information. i:

• Press [TIMER PROG.] during the satellite link timer recording to check the satellite link timer recording in |

progress. I

• When a regular timer recording and the satellite link timer recording are overlapped, those recordings are

; recorded as illustrated below. "

EN 43