Instruction Manual

. ' V i •' :: ■> i-i OOTI MCi '
Symptom
I Remedy
The subtitle language cannot be
changed or turned off.
• Multilingual subtitle are not recorded on the DVD-video.
The angles cannot be changed.
• Multi-angles are not recorded on the DVD-video being played back.
•The angle-change operation is whenever possible as long as the disc
contains a multi-angle portion. Actual change will be performed when
the portion has come up.
•The DVD-video prohibits changing angles.
•Try changing the angle using the DVD-video's menu.
Recording does not stop immediately
after you press [STOP ■].
• It may take a few seconds for the unit to input disc data before
recording stops.
The disc tray does not open when you
press [OPEN/CLOSE^].
• It may take a few seconds for the disc tray to open after you have
recorded or edited a disc. This Is because the unit is adding disc data to
the disc.
"Repairing" appears on the TV screen.
Repatrlng C
In a case you intend to cancel the
repairing process.
• If there is a power failure or unplugging during recording, finalizing,
fornnatting or editing (even after "Repairing" disappears), a repairing
process will begin automatically just after turning the unit on again.
It may take several minutes up to about several hours.
• If you intend to cancel the repairing process, press [^OPEN/CLOSE]
on the front panel, then select "Yes" and press [ENTER]. After that, press
[OPEN/CLOSE to take out the disc. The disc canceled during the
repairing process MAY NOT work.
No image from HDMI connection.
• Check the HDMI connection. (Check the status of the HDMI related
indications.)
• Check whether the connected monitor device or other device supports
HDCP. (This unit will not output a video signal unless the other device
supports HDCP.)
• Check the setting of HDMI.
• Check whether the output format of this unit (HDMI FORMAT) matches
the supported input format of other connected device.
• If the unit is connected to the unauthorized display device with an
HDMI cable, the audlo/video signal may not be output when playing
back a commercial DVD-video.
There is no sound or the sound is
distorted.
• The HDMI sound is not output when "HDMI Audio" is set to "OFF".
• Check the RCA audio cable connection. If you are using HDMI-DVI
conversion cable, you must connect the RCA audio cable, too.
• Check whether the output format of this unit (HDMI FORMAT) matches
the supported input format of other connected device.
There is no picture.
• If you connect the cable to S-VIDEO OUT/ COMPONENT VIDEO OUT /
HDMI OUT jack, try connecting it to AUDIO / VIDEO OUT jack instead.
Picture noise appears.
• Head cleaning for VCR may be necessary. Refer to "Auto Head Cleaning"
(page 5).
• Adjust tracking control for better picture by pressing [TRACKING /\ / \/]
V
while you are playing back a cassette tape.
C
The cassette tape does not play back.
• No cassette tape is inserted.
R
The tape ejected after you press
• Make sure the cassette tape has an erase-protection tab when you
[REC#].
record to a cassette tape. If needed, cover the hole with cellophane
tape.
The remote control does not function.
• Check if a cassette tape Is in this unit.
The motor rotates even when
• The motor may rotate for the duration of approximately 5 minutes for
playback / recording Is stopped.
efficient operation. This is not a malfunction.
104 EN